(1) When using the drilling rig to drill, the driver should be placed in the drilling position, so that the front end is against the rock, and the distribution should be careful to let the drilling rig move forward, so that the drill bit touches the rock; When opening the hole, first quietly let the drilling rig drive, when the drill rod is in place in the rock, it is allocated to the full open position.
(2) Before starting the drilling rig, check whether the charging pressure of the accumulator is normal; Check whether the scouring water pressure and the lubricating air pressure can be; Check whether there is sufficient lubricating oil in the lubricator, and whether the oil supply is appropriate; Check the reverse tendency of the oil pump motor. (3) If the drilling rig cannot open the hole smoothly, it should first assign the rock drill to retreat, and then let the rock drill move forward to open the hole from the beginning.
(4) When replacing the drill bit, the drill bit should be gently pressed against the rock, so that the motor of the drill can be reversed to complete the sensitive unloading head.
(5) The inspection of hydraulic components can only be prevented under the condition of pole cleaning, and after the connecting tissue is removed, it must be quickly plugged with the cleaning tightly matched plug. Before the repaired rock drill is used from scratch, it is necessary to circulate the hydraulic oil into the oil circuit to wash the components of the hydraulic system.
(6) The oil level and oil supply of the lubricator should be checked regularly; The gear with reverse structure is regularly filled with high-temperature grease; Check the oil level in the lubricating oil tank regularly and remove the dirt in the oil tank

01 KEEP CLEAN

Additionally, the tools and technologies used on Mars will have to be adapted. For example, engines that rely on combustion would be less efficient in Mars’ thin atmosphere, requiring alternative propulsion methods. Moreover, the presence of carbon dioxide could be harnessed for in-situ resource utilization, converting CO2 into oxygen for breathing and fuel.

1. Centrifugal Pumps These are the most widely used pumps for slurry applications due to their simple design and efficiency. They operate by using a rotating impeller to increase the velocity of the slurry, which then converts kinetic energy into pressure energy. Centrifugal pumps are suitable for low to medium viscosity slurries and are particularly efficient for transporting large volumes at lower pressures.

The following matters should be paid attention to during the use of the drilling rig, and the correct use can bring greater benefits