Плитагийн хийцэд зориулсан технологи нь сүүлийн жилүүдэд хөгжсөөр байна. Одоогийн байдлаар автоматжуулсан системүүд болон дээд зэргийн технологитай материалуудыг ашиглан плитагийн чанар, бүтээмжийг нэмэгдүүлэх боломжтой. Эдгээр шинэ шийдлүүд нь сумын гулсах, сантехник, системийн ачаалал, давтамжийг үйлдвэрлэлийн явцад зөрчилдүүлэхгүйгээр хянах боломжийг олгодог.

(2) Before starting the drilling rig, check whether the charging pressure of the accumulator is normal; Check whether the scouring water pressure and the lubricating air pressure can be; Check whether there is sufficient lubricating oil in the lubricator, and whether the oil supply is appropriate; Check the reverse tendency of the oil pump motor.

What is a Diesel Air Compressor?

3. Manufacturing Many manufacturing processes depend on rotary air compressors for powering assembly line tools, material handling equipment, and more. Their efficiency can significantly enhance production rates.

Drilling is a fundamental process in various industries, from oil and gas extraction to mineral exploration, construction, and even scientific research. The success of any drilling operation largely depends on the materials used during the drilling process. This article will delve into the different types of drilling materials, their properties, and their significance in enhancing drilling efficiency and safety.

1. Construction In construction, these bits are often used for creating holes in concrete, brick, and masonry. Their ability to handle tough materials makes them a go-to choice for contractors.

(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

4. Operating Conditions Consider temperature, environmental factors, and the availability of power sources. Some pumps may be better suited for extreme conditions.