በቅርብ እንዲሕ ውሳኔ ቢይኖሪ በሚይukkut አነሳምይክቶቱ ለምርም ዳሩ ዬይወዛ፡፡

Bullet teeth are most commonly used in various industrial and construction applications, including

Hammer vs Bajo el Pozo A Clash of Symbolism and Theme

Tungsten is primarily used in the manufacturing of hard materials, such as tungsten carbide, which is widely utilized in cutting tools, abrasives, and various industrial applications. Consequently, the tungsten crusher is essential in industries including mining, metallurgy, and manufacturing. By efficiently crushing and processing tungsten ore, the tungsten crusher enables companies to obtain high-purity tungsten products.

The hammer itself can be operated using a pneumatic or hydraulic system, with hydraulic hammers being the preferred choice in most cases due to their consistent performance and reliability. The drill bit used is often designed specifically for marine environments, featuring reinforced materials and cutting edges optimized for hard substrates.

(1) When using the drilling rig to drill, the driver should be placed in the drilling position, so that the front end is against the rock, and the distribution should be careful to let the drilling rig move forward, so that the drill bit touches the rock; When opening the hole, first quietly let the drilling rig drive, when the drill rod is in place in the rock, it is allocated to the full open position.
(2) Before starting the drilling rig, check whether the charging pressure of the accumulator is normal; Check whether the scouring water pressure and the lubricating air pressure can be; Check whether there is sufficient lubricating oil in the lubricator, and whether the oil supply is appropriate; Check the reverse tendency of the oil pump motor. (3) If the drilling rig cannot open the hole smoothly, it should first assign the rock drill to retreat, and then let the rock drill move forward to open the hole from the beginning.
(4) When replacing the drill bit, the drill bit should be gently pressed against the rock, so that the motor of the drill can be reversed to complete the sensitive unloading head.
(5) The inspection of hydraulic components can only be prevented under the condition of pole cleaning, and after the connecting tissue is removed, it must be quickly plugged with the cleaning tightly matched plug. Before the repaired rock drill is used from scratch, it is necessary to circulate the hydraulic oil into the oil circuit to wash the components of the hydraulic system.
(6) The oil level and oil supply of the lubricator should be checked regularly; The gear with reverse structure is regularly filled with high-temperature grease; Check the oil level in the lubricating oil tank regularly and remove the dirt in the oil tank

4. Minimal Vibration and Noise Unlike traditional drilling methods that may cause significant surface vibration and noise, DTH drilling produces cleaner operations. This characteristic is crucial in urban areas and sensitive environments, leading to fewer disturbances.