Synthetic Rubber Oil Seals - Styrene Butadiene Rubber oil seals, or just SBR oil seals, offer strong resistance to abrasions and lesions, making them an ideal seal for fast-moving machinery. With the ability to withstand extreme temperatures with its heat-aging qualities, they can be used in outdoor components. They are also seen as more cost-effective oil seals than natural rubber.

Garter springs are generally used when the lubricant is oil, as it provides the necessary downward force to maintain a tight seal. However, when grease is the lubricant, garter springs can often be eliminated. Due to its low viscosity, grease doesn’t require as much downward force to maintain an effective seal.

These are comparable to type R and RST, except the outer case does not have a metal reinforcement ring. To compensate, the outside is not made of normal rubber, but a hard, heavy-duty rubber fabric. The advantage is that these types can be made in a split version. They are almost always produced to order, and made of NBR or FKM.

Oil seals are often called grease, fluid, or dirt seals. These seals close spaces between stationary and moving components in mechanical equipment. Oil seals are designed to prevent the escape of lubricant. They also block contaminants from entering machinery. This is especially important in severe environments where heat and foreign objects may be frequently present. They also prevent the mixing of different mediums like lubricating oil and water.

Viton Oil Seals - A synthetic rubber and fluoropolymer elastomer, Viton is used to make oil seals that provide resistance in both high temperature, up to 250°C and low compression set components. They also offer a high resistance to chemicals and abrasions, so they can be used in elements that regularly interact with petroleum and solvents.

What are Oil Seals - Guide to what an Oil Seal is used for

If you have prepared the assembly properly, then you are already largely on your way to a successful installation. The assembly of the oil seal itself is not complex. It is, of course, important that it is done properly in view of the longevity and reliability of the seal.

ERIKS type R (type A according to the DIN standard) is identical in shape to type M, but has a rubber outer case with metal reinforcement on the inside. The rubber creates a good seal in the housing, even if the housing has suffered minor damage or is not in its best condition for other reasons. The RST version has a dust lip. These types are often chosen to replace a type with a metal outer case because they are easier to install and can cope with minor damage to the groove, such as scratches.