fournisseurs de pièces détachées

1.Downhole drilling machine: When drilling a downhole gun hole with a aperture less than 150 mm, in addition to the application of a rock drill, it can also be used to drill a small diameter of 80 ~ 150 mm. When drilling a gun hole with a diameter of less than 70 mm in coal or softer mineral rock, it is generally used to drill or air drill, driven by a motor (or air motor) to drill the drill pipe, and the rock (coal) chips drilled out are discharged through the spiral groove on the drill pipe.

...

Die Herstellung von Sandpumpen ist ein dynamisches Feld, das kontinuierlichen Fortschritt und Anpassungsfähigkeit erfordert. Die Hersteller sind gefordert, innovative Lösungen anzubieten, die den steigenden Anforderungen der Industrie gerecht werden, während sie gleichzeitig effizient und kosteneffektiv arbeiten. Mit dem Fokus auf technologische Entwicklungen und Anpassungen an die Marktentwicklungen werden die Hersteller von Sandpumpen eine wichtige Rolle in der zukünftigen Entwicklung der Bau- und Bergbauindustrie spielen.


...

Submarine hammer drilling, often referred to as underwater percussion drilling, is an advanced technique utilized primarily in marine construction and resource exploration. This method combines the principles of traditional drilling with hydraulic and pneumatic operations, enabling the effective penetration of hard substrates beneath the sea floor. In this article, we will explore the processes, equipment, advantages, and applications of submarine hammer drilling.


...

  • Due to the machine's working environment being prone to intense vibrations and impacts, constantly observe the dynamics of various parts during operation. If you detect abnormal noise or other irregularities, shut down the machine immediately for inspection and repair before resuming operation. If hydraulic system connectors leak or components become loose, shut down the machine for adjustment and tightening. After ensuring everything is normal, you can resume operation. Before completing each shift, lower the hydraulic hammer to the lowest position and retract all other hydraulic cylinders to their shortest length. If moving a distance, keep the mast leaning backward. For the machine's components, accessories, and electrical equipment, perform regular inspections, especially the connections in the wiring of the motor. During operation, there should be designated personnel for guidance. The guide and the operator should check signals with each other before work and cooperate closely. At the start, use a bell or other methods to signal and inform surrounding personnel to move away. The machine should start at a low speed and gradually accelerate to high speed.
  • ...