système de pompage de boue

The DTH hammer operates through a system of compressed air. High-pressure air is directed down the drill string, powering the hammer at the end of the drill bit. The hammer strikes the bit with considerable force, fracturing the rock immediately beneath it. As the bit penetrates further, the broken rock is then cleared from the hole by the same air stream, allowing for continuous drilling without the interruptions often associated with other drilling methods.


...

  • 1.Downhole drilling machine: When drilling a downhole gun hole with a aperture less than 150 mm, in addition to the application of a rock drill, it can also be used to drill a small diameter of 80 ~ 150 mm. When drilling a gun hole with a diameter of less than 70 mm in coal or softer mineral rock, it is generally used to drill or air drill, driven by a motor (or air motor) to drill the drill pipe, and the rock (coal) chips drilled out are discharged through the spiral groove on the drill pipe.
  • ...

    2. Technological Innovation The pump manufacturing industry is continually evolving, with advancements in materials, design, and efficiency. Suppliers that invest in research and development are more likely to offer innovative products that can withstand the demanding conditions of drilling operations. Features like variable speed control, improved hydraulic efficiency, and enhanced wear resistance are highly desirable.


    Поставщики грязевых насосов

    Поставщики

    ...

    At its core, submarine hammer drilling employs a powerful hammer mechanism to drive a drill bit into the seabed. The system utilizes both air and water pressure to deliver repeated impacts on the drill bit, which enables it to break through hard rock formations or sediments that might hinder installation efforts for marine infrastructure. The design of the hammer ensures that the energy is efficiently transmitted to the drill bit, allowing it to operate at significant depths.


    ...

    It is important to know that the shape of the sand has an important impact on the surface finish of the casting. Circular sand is better than triangular sand because the triangular sand has a large gap, which is easy to lead to defects such as porosity; According to the nature of the casting, the sodium silicate quartz sand is selected to form a spalling layer, and combined with the characteristics of cooling and shrinkage of the casting, the surface defects are reduced. Coating a protective layer on the surface of large castings, such as the film on a coated sand mold, can improve the surface finish of the sand mold and reduce the surface defects of the casting.  

    ...