uso da bomba centrífuga vertical

The Slurry Pump Blade Factory epitomizes the spirit of innovation and excellence in engineering. By focusing on advanced technology, environmental sustainability, and the diverse needs of its clients, the factory stands as a crucial player in the global industrial landscape. As industries continue to evolve, the need for reliable and efficient slurry pumping solutions will only grow, and the Slurry Pump Blade Factory is poised to meet that demand with precision and expertise. Through its unwavering commitment to quality and innovation, the factory not only supports current industrial practices but also lays the groundwork for a more sustainable and efficient future.


...

  • 1.The selection of the pump is too large, and the flow and head are larger than the actual condition due to improper selection of the coefficient. This situation makes the pump in the operation process, cavitation phenomenon, resulting in premature damage of the pump flow parts under the combined action of cavitation and abrasion, in the case of serious cavitation, the pump will produce vibration and noise, and even lead to a sharp decline in the flow, head and efficiency of the pump can not run; In addition, the pump in the operation of large flow, will also cause motor overload, heat, serious will burn the motor.
  • ...


    (1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
    (2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
    (3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

    ...

    The design of bullet teeth is key to their effectiveness. Typically made from high-grade steel, these teeth often incorporate carbide tips, which enhance their hardness and wear resistance. The conical shape reduces drag during operation, allowing the auger to rotate smoothly and penetrate through tough material with less effort. Additionally, many bullet teeth designs include replaceable components, letting operators replace worn-out parts without needing to change the entire auger head.


    ...