bombas verticais de lama

En conclusión, los chocks en los laminadores son componentes esenciales que desempeñan un papel crítico en la industria metalúrgica. Su capacidad para soportar altas cargas, proporcionar estabilidad y permitir ajustes precisos es fundamental para garantizar la calidad del producto final. A medida que la tecnología avanza, el futuro de los chocks también se vislumbra prometedor, con mejoras que continuarán impulsando la eficiencia y la sostenibilidad en los procesos de laminado. La atención al mantenimiento y la innovación en su diseño asegurarán que estos elementos vitales sigan funcionando eficazmente en una industria en constante evolución.


...

  • 1.Downhole drilling machine: When drilling a downhole gun hole with a aperture less than 150 mm, in addition to the application of a rock drill, it can also be used to drill a small diameter of 80 ~ 150 mm. When drilling a gun hole with a diameter of less than 70 mm in coal or softer mineral rock, it is generally used to drill or air drill, driven by a motor (or air motor) to drill the drill pipe, and the rock (coal) chips drilled out are discharged through the spiral groove on the drill pipe.
  • ...

  • Due to the machine's working environment being prone to intense vibrations and impacts, constantly observe the dynamics of various parts during operation. If you detect abnormal noise or other irregularities, shut down the machine immediately for inspection and repair before resuming operation. If hydraulic system connectors leak or components become loose, shut down the machine for adjustment and tightening. After ensuring everything is normal, you can resume operation. Before completing each shift, lower the hydraulic hammer to the lowest position and retract all other hydraulic cylinders to their shortest length. If moving a distance, keep the mast leaning backward. For the machine's components, accessories, and electrical equipment, perform regular inspections, especially the connections in the wiring of the motor. During operation, there should be designated personnel for guidance. The guide and the operator should check signals with each other before work and cooperate closely. At the start, use a bell or other methods to signal and inform surrounding personnel to move away. The machine should start at a low speed and gradually accelerate to high speed.
  • ...