manual de triturador de titânio


(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

...

Post-processing of large castings, large foundry processing manufacturers can use liquid sandblasting to clean the oxide scale and residue on the surface of the casting, which can not only remove impurities, but also play a role in polishing and improving the surface finish of the casting; Use grinding wheels, abrasive cloths, sandpaper and other abrasives to remove impurities such as burrs, protrusions and oxide scales on the surface of steel castings, so that the surface is smooth. In addition, methods such as mechanical, electrochemical and chemical polishing can further improve the gloss and corrosion resistance of castings.

...

In conclusion, manganese plays a pivotal role in the manufacturing of jaw plates for crushers in the mining industry. Its unique properties enhance the performance and longevity of these critical components, thereby contributing to the efficiency and cost-effectiveness of mining operations. As the industry evolves, ongoing innovations in material science promise to further improve the effectiveness of manganese jaw plates, ensuring they remain a vital element in the world of mining and crushing.


...

  • 1.The selection of the pump is too large, and the flow and head are larger than the actual condition due to improper selection of the coefficient. This situation makes the pump in the operation process, cavitation phenomenon, resulting in premature damage of the pump flow parts under the combined action of cavitation and abrasion, in the case of serious cavitation, the pump will produce vibration and noise, and even lead to a sharp decline in the flow, head and efficiency of the pump can not run; In addition, the pump in the operation of large flow, will also cause motor overload, heat, serious will burn the motor.
  • ...

    The DTH hammer operates through a system of compressed air. High-pressure air is directed down the drill string, powering the hammer at the end of the drill bit. The hammer strikes the bit with considerable force, fracturing the rock immediately beneath it. As the bit penetrates further, the broken rock is then cleared from the hole by the same air stream, allowing for continuous drilling without the interruptions often associated with other drilling methods.


    ...