pompe à boue et ingénieurs

  • 4. The average flow rate of the pipeline is too low, and the average flow rate of the pipeline is lower than the critical settlement deceleration, resulting in pipeline blockage and unable to transport slurry normally. Through the above examples, it can be seen that the selection of ZJ series slurry pump is more complicated, and if any link makes a mistake, it may lead to the mistake of the entire selection, causing irreparable losses to users, and having an adverse impact on their reputation. Therefore, in the selection, we must pay attention to the values of several key coefficients and calculate them carefully to achieve accuracy, so that the ZJ series slurry pump can fully reflect its advantages in field application.

    • ...
    pompe à boue et ingénieurs2025-08-15 21:28
    967

    In conclusion, the sales of directed drilling rods are set to rise as the industry adapts to the growing demand for efficient and environmentally friendly drilling solutions. The convergence of technology and traditional drilling practices will redefine the future of this market, ensuring that directed drilling remains at the forefront of resource extraction strategies. As firms invest in innovation and sustainability, directed drilling rods will undoubtedly become indispensable tools in the quest for energy security and environmental stewardship.


    ...
    pompe à boue et ingénieurs2025-08-15 21:16
    2930


    (2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.

    ...
    pompe à boue et ingénieurs2025-08-15 20:42
    1076

    1.Downhole drilling machine: When drilling a downhole gun hole with a aperture less than 150 mm, in addition to the application of a rock drill, it can also be used to drill a small diameter of 80 ~ 150 mm. When drilling a gun hole with a diameter of less than 70 mm in coal or softer mineral rock, it is generally used to drill or air drill, driven by a motor (or air motor) to drill the drill pipe, and the rock (coal) chips drilled out are discharged through the spiral groove on the drill pipe.

    ...
    pompe à boue et ingénieurs2025-08-15 20:24
    1704