perfuração de martelo de buraco submersível pdf


(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

...

A DTH hammer is a type of percussion drilling tool that functions by delivering a series of rapid impacts to the drill bit, which then breaks the rock or other materials beneath the surface. The term down-the-hole refers to the hammer being placed directly above the drill bit, allowing the energy from the hammer to be transferred efficiently into the drill bit. This method enhances the speed and effectiveness of drilling operations, particularly in hard rock formations.


...

La innovación en los materiales y procesos de fabricación también ha impactado en el desarrollo de chocks para laminadores. Hoy en día, se utilizan aleaciones de alta resistencia y tecnologías avanzadas de fabricación para producir chocks más duraderos y eficientes. Esto no solo mejora la vida útil de los chocks, sino que también contribuye a la sostenibilidad de los procesos industriales al reducir la necesidad de reemplazos frecuentes.


...


(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
The horizontal slurry pump should be used for regular maintenance. This can effectively avoid the problem of slurry pump blockage, and if you encounter these problems in the process of using slurry pump in the later stage, you can solve them according to the above steps.

...