equipo de perforación minera
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
1. การก่อสร้าง ในสถานที่ก่อสร้าง คอมเพรสเซอร์ CFM 185 สามารถจ่ายลมให้กับเครื่องมือที่ใช้ในการขนย้ายวัสดุ หรือการตัดและเจาะที่มีความต้องการใช้งานที่ต่อเนื่อง ซึ่งช่วยเพิ่มประสิทธิภาพการทำงานและลดเวลาที่สูญเสียไป
compresseur d'air cfm 185

Advantages of DTH Hammer Drilling
4. 이동성 많은 디젤 압축기는 이동이 용이하도록 설계되어 있습니다. 바퀴가 달려 있어 다양한 작업 현장에 쉽게 이동할 수 있으며, 이는 작업의 유연성을 높이는 데 도움이 됩니다.
compresseur d'air diesel 90 cfm

1. Slurry Characteristics The composition, concentration, and size of solids in the slurry must be thoroughly analyzed. A high solid concentration requires a pump that can withstand wear and manage viscosity effectively.
Additionally, submarine hammer drilling is a versatile technique, suitable for various applications, including the installation of underwater pipelines, foundations for offshore structures, and the recovery of geological samples for research and analysis. This adaptability makes it an essential tool in the fields of marine engineering, environmental research, and resource extraction.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.