perforación de aguas subterráneas


(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

...

El mantenimiento de los chocks es vital para el funcionamiento eficiente de los laminadores. Con el tiempo, el desgaste natural y las condiciones operativas pueden debilitar la estructura de los chocks. Las inspecciones regulares son necesarias para detectar cualquier signo de daño, como grietas o deformaciones. Ignorar el mantenimiento adecuado puede llevar a fallas catastróficas, que no solo provocan tiempos de inactividad prolongados, sino que también pueden resultar en costosas reparaciones y en la pérdida de materia prima.


...

In today’s world, environmental sustainability is a paramount concern. The Slurry Pump Blade Factory is at the forefront of integrating eco-friendly practices into its manufacturing processes. The factory implements energy-efficient technologies and recycles materials wherever possible, reducing its carbon footprint. Furthermore, the pumps produced are designed to minimize energy consumption during operation, contributing to lower greenhouse gas emissions in various industrial applications.


...


(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
The horizontal slurry pump should be used for regular maintenance. This can effectively avoid the problem of slurry pump blockage, and if you encounter these problems in the process of using slurry pump in the later stage, you can solve them according to the above steps.

...