The submersible drilling rig, available in both internal combustion and electric models, is a device for drilling holes in rocks. The characteristics of drill drilling is outstanding, according to different characteristics can be divided into many varieties, different varieties of drill drilling scope is not the same, facing the classification of drill drilling, the way is briefly introduced as follows:

5, the drilling machine uses semi-automatic cloud dynamic disassembling drill pipe, high efficiency.
Third, the structure of the drilling rig:
The drill tool is composed of drill pipe, ball tooth drill bit and impactor. When drilling, two drill rods are used to drill. The reverse air supply structure is composed of a reverse motor, a reverse reducer, and a reverse air supply inverter. The reverse reducer is

(4) When replacing the drill bit, the drill bit should be gently pressed against the rock, so that the motor of the drill can be reversed to complete the sensitive unloading head.

Understanding Down-the-Hole Hammer Drilling

The mining industry relies heavily on self-priming slurry pump solutions for dewatering, tailings management, and ore processing. These pumps are built to withstand the harsh conditions of mining environments, ensuring reliable performance and operational continuity.

- Geothermal Energy The ability to create deep, straight boreholes makes DTH drilling an excellent choice for geothermal energy projects, allowing reliable access to thermal resources.

Applications

(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.