(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

Additionally, submarine hammer drilling is a versatile technique, suitable for various applications, including the installation of underwater pipelines, foundations for offshore structures, and the recovery of geological samples for research and analysis. This adaptability makes it an essential tool in the fields of marine engineering, environmental research, and resource extraction.

Understanding Submarine Hammer Drilling

Mars’ low atmospheric pressure also contributes to unique weather phenomena. The thin atmosphere allows for significant temperature fluctuations, with daytime temperatures at the equator reaching up to 20 degrees Celsius (68 degrees Fahrenheit) but plunging to -80 degrees Celsius (-112 degrees Fahrenheit) at night.

1. Construction Sites Commonly used to power tools like jackhammers, air nailers, and other pneumatic equipment essential for construction projects.

The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high

2. Reduced Friction The helical shape minimizes friction between the drill bit and the material. This reduction in friction leads to less wear and tear on both the drill bit and the drilling equipment, extending their lifespan.

It is important to know that the shape of the sand has an important impact on the surface finish of the casting. Circular sand is better than triangular sand because the triangular sand has a large gap, which is easy to lead to defects such as porosity; According to the nature of the casting, the sodium silicate quartz sand is selected to form a spalling layer, and combined with the characteristics of cooling and shrinkage of the casting, the surface defects are reduced. Coating a protective layer on the surface of large castings, such as the film on a coated sand mold, can improve the surface finish of the sand mold and reduce the surface defects of the casting.  

Плитагийн хийцэд зориулсан технологи нь сүүлийн жилүүдэд хөгжсөөр байна. Одоогийн байдлаар автоматжуулсан системүүд болон дээд зэргийн технологитай материалуудыг ашиглан плитагийн чанар, бүтээмжийг нэмэгдүүлэх боломжтой. Эдгээр шинэ шийдлүүд нь сумын гулсах, сантехник, системийн ачаалал, давтамжийг үйлдвэрлэлийн явцад зөрчилдүүлэхгүйгээр хянах боломжийг олгодог.