18 буровых стержней
Die Technologie für Sandpumpen hat in den letzten Jahren erhebliche Fortschritte gemacht. Eine der wichtigsten Entwicklungen ist die Verbesserung der Materialien, die für die Pumpen verwendet werden. Hochfeste, korrosionsbeständige Legierungen und Verbundwerkstoffe erhöhen die Lebensdauer der Pumpen und verringern den Wartungsaufwand. Darüber hinaus haben viele Hersteller begonnen, auf energieeffiziente Antriebssysteme umzusteigen, die den Energieverbrauch reduzieren und die Betriebskosten senken.
- Fiberglass Used in certain applications, fiberglass casing is lightweight and resistant to corrosion, making it suitable for certain environments.
matériaux de forage

5. Ease of Use Many modern models come equipped with user-friendly features including digital controls, automatic shut-off functions, and noise reduction technologies. This makes them accessible for both seasoned technicians and novices alike.
Down-the-hole hammer drilling is a technique used primarily for drilling boreholes in hard rock applications. It employs a pneumatic hammer, situated directly at the drill bit, to deliver high-impact blows that effectively break up the rock. This method contrasts with traditional rotary drilling, where the drill bit operates at the surface and relies on torque and weight to penetrate the ground.
Understanding Vertical Slag Pumps
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.