3. Acier inoxydable Pour des environnements particulièrement corrosifs, comme dans l’exploration en milieu marin, l'acier inoxydable est souvent la meilleure option. Bien qu'il soit généralement plus coûteux que l'acier au carbone, sa résistance à la corrosion justifie cet investissement.

When considering the acquisition of a tungsten crusher, several factors must be taken into account. Firstly, the capacity of the crusher should align with the operational requirements. It is essential to evaluate the expected throughput and ensure that the chosen model can meet these demands efficiently.

3. Open-air drilling rig: according to the different working mechanism of crushing ore and rock, it is divided into steel rope percussion drill, drilling rig, cone drill and rotary drill. Because of low efficiency, the steel rope percussion drill has been gradually replaced by other drilling RIGS. The drill pipe drives the pneumatic impactor and the drill bit to rotate together, and the piston of the pneumatic impactor is used to impact the drill bit to break the ore and rock, which is usually used in small and medium-sized mines to drill holes with a diameter of 80 to 250 mm.

3. Flow Rate and Pressure Determine the required flow rate and the pressure at which the slurry needs to be transported. This will influence the type of pump chosen, as different pumps have specific performance curves.

(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

Conclusion

디젤 공기 압축기란?

Shunga qaramay, to'g'ri burg'ulash vositasini tanlash va uning narxini aniqlashda har bir ishlab chiqaruvchi o'z ehtiyojlariga va budjetiga mos variantni izlaydi. Masalan, yirik korxonalar ko'pincha yuqori sifatli va narxli asboblarga sarmoya kiritsa, kichik bizneslar va shaxsiy foydalanuvchilar ko'proq iqtisodiy variantlarga e'tibor berishadi.

Conclusion