cone crusher bearings
Les barres de forage sont traditionnellement fabriquées en acier, mais différents alliages et traitements peuvent être utilisés pour répondre aux besoins spécifiques de durabilité et de robustesse. En général, les matériaux utilisés doivent résister à des conditions de travail extrêmes, notamment à des pressions élevées, à des températures élevées et à l'usure due à l'abrasion.
The fractional head hammer's unique design makes it suitable for a wide range of applications
The main components of submarine hammer drilling equipment include the drill rig, hammer, drill pipes, and the drill bit. The drill rig is often mounted on a surface vessel or a floating platform and is designed to support the excessive weight and dynamic forces encountered during drilling operations.
Cleaning method:
Fill the pump with water
Open the inlet door and clean the clogged part of the pipeline
Plug the leak area and check whether the packing is wet or compressed
Cleaning method:
Fill the pump with water
Open the inlet door and clean the clogged part of the pipeline
Plug the leak area and check whether the packing is wet or compressed
- Geothermal Energy The ability to create deep, straight boreholes makes DTH drilling an excellent choice for geothermal energy projects, allowing reliable access to thermal resources.
As a merit in the mining of rock, the drilling rig has to be mentioned. In addition, the drilling rig can also be used as a breaker to break up hard layers such as concrete. According to its power source, the rock drill can be divided into four categories: pneumatic rock drill, internal combustion rock drill, electric rock drill and digging and changing drill.
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
When it comes to the advantages of manganese jaw plates, their longevity and resilience stand out. The ability to withstand abrasive materials without excessive wear ensures that mining operations can run smoothly with minimal interruptions. This aspect not only contributes to cost savings but also reduces the frequency of maintenance and replacement of jaw plates.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.