...
2025-08-15 03:54
622
...
2025-08-15 03:05
2188
...
2025-08-15 02:49
2417
...
2025-08-15 02:31
1625
...
2025-08-15 02:26
2047
...
2025-08-15 02:23
367
...
2025-08-15 02:17
2815
...
2025-08-15 02:15
1887
...
2025-08-15 02:08
2043
...
2025-08-15 02:05
875
All are fitted with a spring to preload the sealing lip. All these types are for non-pressurised or low-pressure applications up to 0.5 bar for diameters of a limited size. For diameter of 500 mm or more, the maximum pressure is 0.1 bar. For higher pressures, special types or PTFE lip seals can be used.
One way to recognize an improperly installed seal is by checking whether or not there is uneven shearing of the rubber after use. If this is evident, adjust by aligning the installation tools properly before pressing the seal into place.
ELASTOMER MATERIAL + PTFE – THE PERFECT COMBINATION

diesel spark plugs. This ensures that the fuel-air mixture is ignited properly and that the combustion process is as efficient as possible. This is important for diesel engines, which rely on precise combustion to generate power.
Fluid side face The front-end face of the seal is called the nose. The nose is made of rubber and forms a gasket seal when compressed on the housing shoulder.
Lubricant
GVST