подводная труба молотка

A jaw plate is a vital part of a jaw crusher. Typically, these plates are made of high-strength steel or manganese steel and are designed to withstand the immense pressure and force that occurs during crushing operations. Functionally, jaw plates serve as the primary point for the raw materials to be crushed. They work in tandem with the stationary jaw and the movable jaw, creating a V-shaped cavity that compresses materials to break them down into manageable sizes.


...

At its core, submarine hammer drilling employs a powerful hammer mechanism to drive a drill bit into the seabed. The system utilizes both air and water pressure to deliver repeated impacts on the drill bit, which enables it to break through hard rock formations or sediments that might hinder installation efforts for marine infrastructure. The design of the hammer ensures that the energy is efficiently transmitted to the drill bit, allowing it to operate at significant depths.


...


(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
The horizontal slurry pump should be used for regular maintenance. This can effectively avoid the problem of slurry pump blockage, and if you encounter these problems in the process of using slurry pump in the later stage, you can solve them according to the above steps.

...

The primary function of a drainage pump is to collect and remove water from a specified area. Most commonly used in basements, crawl spaces, and construction sites, these pumps are equipped with a float switch that activates the pump when water reaches a certain level. Once the water is detected, the pump will turn on, drawing the water into its casing and expelling it through a discharge pipe to a designated drainage area. This process continues until the water level drops below the float switch, at which point the pump turns off.


...