dth hammer manufacturers

One of the most critical components of a jaw crusher is the jaw plates. These are the surfaces that come into direct contact with the material being crushed. They typically come in two varieties the fixed jaw plate and the movable jaw plate. The fixed jaw plate is stationary and mounted on the frame, while the movable jaw plate moves back and forth, creating a crushing motion. The wear and tear of jaw plates are significant since they constantly encounter abrasive materials. Hence, they are often manufactured from high-grade manganese steel to enhance their durability.


...

The DTH hammer operates through a system of compressed air. High-pressure air is directed down the drill string, powering the hammer at the end of the drill bit. The hammer strikes the bit with considerable force, fracturing the rock immediately beneath it. As the bit penetrates further, the broken rock is then cleared from the hole by the same air stream, allowing for continuous drilling without the interruptions often associated with other drilling methods.


...

  • 1.The selection of the pump is too large, and the flow and head are larger than the actual condition due to improper selection of the coefficient. This situation makes the pump in the operation process, cavitation phenomenon, resulting in premature damage of the pump flow parts under the combined action of cavitation and abrasion, in the case of serious cavitation, the pump will produce vibration and noise, and even lead to a sharp decline in the flow, head and efficiency of the pump can not run; In addition, the pump in the operation of large flow, will also cause motor overload, heat, serious will burn the motor.
  • ...