Портативный воздушный компрессор дизельного двигателя

The DTH hammer operates through a system of compressed air. High-pressure air is directed down the drill string, powering the hammer at the end of the drill bit. The hammer strikes the bit with considerable force, fracturing the rock immediately beneath it. As the bit penetrates further, the broken rock is then cleared from the hole by the same air stream, allowing for continuous drilling without the interruptions often associated with other drilling methods.


...

Bullet teeth are specialized cutting tools utilized primarily in auger operations for drilling through tough soil, rock, and other challenging materials. Characterized by their streamlined, conical design, these teeth are engineered to penetrate efficiently and minimize the required drilling force. Their unique shape allows for optimal cutting performance while maintaining durability in demanding conditions.


...

The submersible drilling rig, available in both internal combustion and electric models, is a device for drilling holes in rocks. The characteristics of drill drilling is outstanding, according to different characteristics can be divided into many varieties, different varieties of drill drilling scope is not the same, facing the classification of drill drilling, the way is briefly introduced as follows:

...


(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

...


(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

...

Despite the advantages, there are challenges associated with sourcing pumps from China. Language barriers, differences in regulatory standards, and varying quality control measures can pose risks. Therefore, it is essential for purchasers to conduct due diligence, engage with reliable suppliers, and possibly seek third-party inspections to ensure that the products meet required specifications.


...