- Adaptability Different geological formations require specific materials. Choosing the right tools can help overcome challenges posed by varying rock types and conditions.
- Galvanized iron wire is divided into hot galvanized wire and cold galvanized wire, using low carbon steel wire processing, after drawing molding, pickling rust removal, high temperature annealing, hot galvanized, cooling and other processes. It has good toughness and elasticity, and the amount of zinc can reach 300 grams/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Galvanized iron wire can be cut off in the construction of the tie wire, the length of 20cm, 30cm and 40cm, can be cut off according to requirements.
Wire factory reminds you in the purchase of galvanized wire, should be stored in dry, ventilated conditions, do not contain corrosive gases, do not mix with organic volatile gas produced paint, plastic and other substances in a good environment. If possible, we can add reliable inner packaging for galvanized parts, and put desiccant. If the zinc layer of white spots and long hair, can only be removed by mechanical methods, and then normal passivation, or completely washed off the zinc layer after re-plating.
- The most obvious gap in a short time is the cross section of this piece, hot dip galvanized barbed wire because it is the surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
The weight calculation method of hexagonal net is: the weight calculation method of hexagonal net: silk meridian.× silk meridian.× base x length x width ÷2=kg base: 1/2′=2.151′=1.273/4′=1.65/8′=1.875/4′=1.091′x1/2′ : 3′=0.4 silk warp. x silk warp. X 2x length x width ÷8×3=kg
- Large hexagonal net called stone cage net, mainly used for mountain preparedness protection, hydraulic construction, etc. Small wire hexagonal net is used as a good material for culture, will twist the hexagonal net in the welding of the iron frame on the hexagonal net welding into chicken cage, pigeon cage, rabbit cage and other cage, hexagonal net is an excellent material for culture with net.
- Although many species of parrots are native to tropical regions, birds are susceptible to heat stroke. So in warm weather, don’t put the cage directly in front of a window in direct sunlight, or in an unshaded and unventilated garden.
The reason why there are black spots in wire mesh welding is that the action of wire feeding should be timely filled in the melting time, and the development should be appropriate. There is no argon gas, long burning, large current, long distance, blunt tungsten needle and high molten pool temperature are the fundamental reasons for blackening. Continuous burning, is about active welding machine energy selection, machine welding will appear black spots.
- Hot dip galvanizing is the plating of zinc layer on the surface of Angle steel, channel steel and other metals to achieve the appearance of convenience and rust prevention of metal. Hot-dip zinc processing plants use zinc tin solution to prevent corrosion on the workpiece. This new technology can extend the corrosion time by up to five times, which is usually used in outdoor construction. Because the principle of action is not the same, so the role of the workpiece is not the same. The appearance of hot dip zinc plant is only to expand the scope of action.
Hot dip galvanizing is dipped in zinc liquid melted by heating, with fast production speed and thick but uneven coating. The market allows a low thickness of 45 microns and a high of more than 300 microns. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Application range of hot dip galvanizing: because the coating is thicker, hot dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for iron and steel parts in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, power transmission, shipbuilding and other industries, in the field of agriculture such as sprinkler irrigation, greenhouse and construction industry such as water and gas transmission, wire casing, scaffolding, Bridges, highway guardrail and other aspects, has been widely used.
There are many kinds of specifications for crack resistant welding mesh used in the construction industry. The commonly used specifications are as follows:
- The drawing process of the waste product has a great influence on the function of the product. The general selection of about 90% of the larger total surface reduction rate (see area reduction rate) and the smaller pass surface reduction rate (about 23%), to ensure the endurance of the product. On the high strength spring steel wire, pulling should be controlled each time the temperature of the steel wire outlet is lower than 150℃, to prevent the steel wire due to strain aging and change the crack, which is the main drawback of steel wire waste.
The large hexagonal mesh is called the stone cage net. Stone cage net before delivery, must be folded into a simple surface, packed compressed after delivery. Then put it in the right position to open, and then the block diameter suitable stone into the cage, the cover is tight, and then the various stone cage net and the adjacent stone cage net tied up.
Moderate rates of foam formation may be harmless. The presence of small, homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of excessive solid particles can cause an explosion. Using activated carbon mat to remove surface active substances, or through filtration to make the foam is not too stable, this is an effective measure; Other measures should also be taken to reduce the amount of surfactant introduced to Z.
Post time: 31-08-22
Post time: 08-06-22- Packaging is also very important, cut wire to do a good job in the bundle with plastic film tightly packed, and then in the regular box, to fill the whole box is very full and sealed, it is best not to have a half box of conditions, if there is a half box to fill with foam and other things, so that in the transit cut wire will not receive a little damage.
Because of the high carbon content, simple cracks occur during water quenching, so double liquid quenching (water quenching + oil cooling) is mostly used, and oil quenching is mostly used for small cross section parts. This type of steel is generally used after quenching by medium temperature tempering or normalizing or in the surface quenching state. Mainly used for manufacturing spring and wear-resistant parts.
1. Electroplating process control
- 1. Weight
- Hot dip galvanizing, also known as hot dip galvanizing, is a method of obtaining a metal covering by immersing a steel member in a molten zinc solution. With the rapid development of high-voltage transmission, transportation and communication, the protection requirements for steel parts are becoming higher and higher, and the demand for hot-dip galvanizing is also increasing. Usually the thickness of electric galvanized layer is 5 ~ 15μm, and the large roll galvanized wire layer is generally more than 35μm, even up to 200μm. Hot dip galvanizing has good covering ability, dense coating and no organic inclusions.
We must have a certain understanding of the hexagonal net, we are swayed by the beautiful shape of the hexagonal net, not only the shape of the hexagonal net is very beautiful, in fact, the practical value of survival is very high. The relevant information of Shaojie should be very clear to know that the high speed road guardrail network, hexagonal mesh of all kinds of guardrail network, the value of the high speed road is more prominent, it is not only used in a variety of roads, in a variety of sports ball venues and landslides to take care of, but also to reach the very close utility.
- Avoid hanging cages near heaters, as failure to dissipate heat can interfere with bird molting.
- 4. Rinse the foam off your cat thoroughly.
- The most obvious gap in a short time is the cross section of this piece, hot dip galvanized barbed wire because it is the surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
- With a large pickpocket used for steel wire, into the zinc liquid before the surface of the zinc ash stirring; Use a small outlet for galvanized steel wire; Zinc pot steel wire outlet in 30 minutes, with pickpockets back and forth, until the large, floating zinc residue into brown, real zinc ash, zinc ash surface. The extracted zinc ash should be brown yellow real zinc ash, zinc surface, effectively reduce zinc consumption. This is one of the measures to reduce zinc consumption, but it is also a real problem, which has not been solved for many years.
Large roll galvanized wire is processed from low carbon steel wire rod, after drawing forming, pickling rust removal, high temperature annealing, hot dip galvanized. Cooling and other process processes. Galvanized wire is divided into hot galvanized wire and cold galvanized wire (electric galvanized wire). Large roll galvanized wire has good toughness and elasticity, the amount of zinc can reach 300 g/square meter, with thick galvanized layer, strong corrosion resistance and other characteristics.
Because the size of the plane or the surface of the object in the urban area is relatively small, many stadiums are built in the more prosperous and lively section, with the hexagonal net as a protective barrier, so it greatly reduces the spherical three-dimensional fly out of the field so as to affect the traffic order of bad things.
One is the frame isolation net, guardrail net with frame, frame using material cold plate belt welded into the square tube, usually 2*3 thickness 1.2 thick, the middle for low carbon steel wire welding mesh, wire diameter can choose another welding aperture can also choose, for example, customers want good quality long service time, you can choose thick wire diameter, small welding aperture, Such mesh is not only high quality, but also long service life, customized mesh and frame after welding, surface treatment to reach the customer needs of goods.
Now most people want to choose a few when choosing barbed wire material better thorn rope, but the special barbed wire the better, not right, it is important to choose which model is most suited to their own thorn rope,, although is very simple product, but in the use of these products are for specific situation is different, and has a different effect, Maybe now consumers do not have too much concept of blade barbed rope, in fact, such barbed rope products have a higher safety factor. In addition, there are also more and more barbed rope, dazzling reasons, here is an example to illustrate the choice of special barbed rope.