forage de puits sous-marins
1. Submersible Pumps These pumps are designed to operate submerged in water. They work by pushing water to the surface as opposed to pulling it. This type is commonly used in residential basements and flooded areas due to its efficiency and effectiveness in removing large volumes of water.
1. Steel Manufacturing In steelmaking, large amounts of slag are produced during the refining process. Vertical slag pumps effectively transport this byproduct to treatment facilities or disposal areas.
4. Minimal Vibration and Noise Unlike traditional drilling methods that may cause significant surface vibration and noise, DTH drilling produces cleaner operations. This characteristic is crucial in urban areas and sensitive environments, leading to fewer disturbances.
After 100 hours of operation, replace the engine oil, gear oil, motor oil, and brake fluid.
In addition, collaboration and partnerships between companies in the energy and technology sectors are becoming more common. These alliances foster innovation and lead to the development of advanced directed drilling systems that can adapt to varying geological conditions, further advancing the industry's capabilities.
Advantages of DTH Hammer Drilling
The horizontal slurry pump should be used for regular maintenance. This can effectively avoid the problem of slurry pump blockage, and if you encounter these problems in the process of using slurry pump in the later stage, you can solve them according to the above steps.
The horizontal slurry pump should be used for regular maintenance. This can effectively avoid the problem of slurry pump blockage, and if you encounter these problems in the process of using slurry pump in the later stage, you can solve them according to the above steps.
Cleaning method:
Fill the pump with water
Open the inlet door and clean the clogged part of the pipeline
Plug the leak area and check whether the packing is wet or compressed
Fill the pump with water
Open the inlet door and clean the clogged part of the pipeline
Plug the leak area and check whether the packing is wet or compressed