What Benefits Do Oil Seals Provide?

MH: O.D. wall is a rubber material
HM: O.D. wall is a metal case
MH(S)H: O.D. wall is metal with a reinforced inner metal case

The material of the sealing lip is chosen according to the liquid to be sealed and the rotational speed. For larger shafts, an NBR sealing lip can cope with surface speeds of up to 10-12 m/s, while an FKM lip is suitable for speeds of up to 35-38 m/s. 

Under the action of the skeleton oil seal, the rigidity of the oil film just makes the oil film and the air contact end form a crescent surface, which prevents the leakage of the working medium and realizes the sealing of the rotating shaft. The sealing ability of the oil seal depends on the thickness of the oil film on the sealing surface. If the thickness is too large, the oil seal will leak; if the thickness is too small, dry friction may occur, causing the oil seal and shaft to wear; if there is no oil film between the sealing lip and the shaft, it is easy to cause heat and wear. . Therefore, when installing, it is necessary to apply some oil on the sealing ring, and at the same time ensure that the skeleton oil seal is perpendicular to the axis line. If it is not perpendicular, the sealing lip of the oil seal will drain the lubricating oil from the shaft, which will also lead to excessive sealing of the lip. wear. During operation, the lubricant in the casing seeps out a little, so that it is ideal to form an oil film on the sealing surface.

Remove the key and keep it safe until ready to refit the pulley.

Cover the valve gear with a clean cloth to prevent dirt getting into the working parts of the engine.