It is suitable as an alternative to titanium dioxide when higher acid resistance is required, such as in adhesive joints and sealants. 

Titanium dioxide is a naturally-occurring mineral found in the earth’s crust. Because of its white color, opaqueness, and ability to refract light, the ingredient is often used as a pigment, brightener, and opacifier, which is an ingredient that makes a formulation more opaque. Titanium dioxide is also a UV filter and so is an effective active ingredient in sunscreens. It’s often used in cosmetic loose and pressed powders, especially “mineral powder” cosmetics, in addition to other cosmetics, lotions, toothpaste, and soap.

There's also evidence that inhaling titanium dioxide particles can be dangerous. That's mainly a concern for industrial workers. In places where it's produced, or where it's used to make other products, workers can breathe it in as a dust. The Occupational Health and Safety Administration has exposure standards manufacturers must meet.

Despite its many advantages, the production of lithopone is not without its challenges. The raw materials used to make lithopone, particularly zinc sulfide, can be expensive and difficult to source. In addition, the production process itself can be complex and energy-intensive, requiring specialized equipment and skilled workers to operate. As a result, lithopone manufacturers must carefully manage their operations to ensure they remain competitive in the market.

The skin of an adult person is, in most places, covered with a relatively thick (∼10 μm) barrier of keratinised dead cells. One of the main questions is still whether TiO₂ NPs are able to penetrate into the deeper layers of the skin. The majority of studies suggest that TiO₂ NPs, neither uncoated nor coated (SiO₂, Al₂O₃ and SiO₂/Al₂O₃) of different crystalline structures, penetrate normal animal or human skin. However, in most of these studies the exposures were short term (up to 48 h); only few long-term or repeated exposure studies have been published. Wu et al.83 have shown that dermal application of nano-TiO₂ of different crystal structures and sizes (4–90 nm) to pig ears for 30 days did not result in penetration of NPs beyond deep epidermis. On the other hand, in the same study the authors reported dermal penetration of TiO₂ NPs with subsequent appearance of lesions in multiple organs in hairless mice, that were dermal exposed to nano-TiO₂ for 60 days. However, the relevance of this study for human exposure is not conclusive because hairless mice skin has abnormal hair follicles, and mice stratum corneum has higher lipid content than human stratum corneum, which may contribute to different penetration. Recently Sadrieh et al. performed a 4 week dermal exposure to three different TiO₂ particles (uncoated submicron-sized, uncoated nano-sized and coated nano-sized) in 5 % sunscreen formulation with minipigs. They found elevated titanium levels in epidermis, dermis and in inguinal lymph nodes, but not in precapsular and submandibular lymph nodes and in liver. With the energy dispersive X-ray spectrometry and transmission electron microscopy (TEM) analysis the authors confirmed presence of few TiO₂ particles in dermis and calculated that uncoated nano-sized TiO₂ particles observed in dermis represented only 0.00008 % of the total applied amount of TiO₂ particles. Based on the same assumptions used by the authors in their calculations it can be calculated that the total number of particles applied was 1.8 × 10¹³ /cm² and of these 1.4 x10⁷/cm² penetrated. The surface area of skin in humans is around 1.8 m²  and for sun protection the cream is applied over whole body, which would mean that 4 week usage of such cream with 5 % TiO₂ would result in penetration of totally 2.6 × 10¹⁰ particles. Although Sadrieh et al.concluded that there was no significant penetration of TiO₂ NPs through intact normal epidermis, the results are not completely confirmative.