Application

General Information

Mineral processing is used to separate useful minerals from gangue minerals by crushing, screening and sieving to obtain crude oil for industrial use. There are ferrous metals, non-ferrous metals, rare metals, precious metals and so on.As for beneficiation methods, there are gravity separation, magnetic separation, electrostatic separation and chemical separation. One or more methods are used in industrial applications. 

Product Requirement Planning

1. Pumps for non-corrosive applications can be constructed with double housing. The standard of wet parts material can be lowered.
2. For high temperature applications, cavitation performance should be enhanced.
3. Develop low abrasive materials.

General Information

Sintering, ironmaking, steelmaking and rolling are the main industrial processes used by iron and steel enterprises. As for the selection of pumps in the process of steel manufacturing and finishing, the main use of pumps for sintering desulfurization, blast furnace slag washing, converter, continuous casting machine cooling and rolling process cooling systems. Slurry pump is mainly used in sintering desulfurization and blast furnace slag washing process, double suction pump and sludge pump are mostly used in converter, continuous casting machine cooling and steel rolling process cooling system. Industrial process introduction and how to choose the pump, mainly about the blast furnace slag washing process with industrial pumps

Product requirement planning

1. Pumps for non-corrosive applications can be constructed with housing. The standard of wet parts material can be lowered.
2. For high temperature applications, cavitation performance should be enhanced.
3. Develop low abrasive materials.
4. Some pumps need direct drive, develop direct drive types.

Product Requirement Planning

1. No special requirements for single or double shell.
2. The shaft seal is sealed by an extruder. Packing seals and sealing water can affect industrial processing.
3. Use the inlet or outlet metric flange. For flanges, it is best to use the same standard. It is recommended to use 1MPa (exit) and 0.6MPa (entrance).
4. Filter press feed pump: flow and head vary greatly. The whole operation is not overloaded. The competitor uses a double impeller structure.