5. Enhanced Safety Safety is a paramount concern in drilling operations. DTH hammer drilling minimizes the risks associated with traditional drilling methods, such as drill string failures or excessive vibration. The compact design of DTH equipment also allows for easier handling and reduced risk of accidents on job sites.

Conclusion

Drainage pumps are essential in various settings

The operation of a slurry pump involves creating a vacuum that moves the slurry from one point to another. They are typically centrifugal pumps, meaning they utilize rotating impellers to increase the fluid’s velocity, subsequently converting the kinetic energy into pressure energy. This process allows for the efficient movement of slurries over long distances, which is particularly important in large mining operations.

2. Pump Material The selected materials should offer resistance to erosion and corrosion, especially when handling abrasive slurries. Common materials include rubber-lined components, stainless steel, and high-chrome alloys.

Conclusion

Conclusion

Conclusion

(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.