สรุป

A jaw plate is a vital part of a jaw crusher. Typically, these plates are made of high-strength steel or manganese steel and are designed to withstand the immense pressure and force that occurs during crushing operations. Functionally, jaw plates serve as the primary point for the raw materials to be crushed. They work in tandem with the stationary jaw and the movable jaw, creating a V-shaped cavity that compresses materials to break them down into manageable sizes.

3. Flow Rate and Pressure Determine the required flow rate and the pressure at which the slurry needs to be transported. This will influence the type of pump chosen, as different pumps have specific performance curves.

(3) If the drilling rig cannot open the hole smoothly, it should first assign the rock drill to retreat, and then let the rock drill move forward to open the hole from the beginning.

The hammer itself can be operated using a pneumatic or hydraulic system, with hydraulic hammers being the preferred choice in most cases due to their consistent performance and reliability. The drill bit used is often designed specifically for marine environments, featuring reinforced materials and cutting edges optimized for hard substrates.

It is important to know that the shape of the sand has an important impact on the surface finish of the casting. Circular sand is better than triangular sand because the triangular sand has a large gap, which is easy to lead to defects such as porosity; According to the nature of the casting, the sodium silicate quartz sand is selected to form a spalling layer, and combined with the characteristics of cooling and shrinkage of the casting, the surface defects are reduced. Coating a protective layer on the surface of large castings, such as the film on a coated sand mold, can improve the surface finish of the sand mold and reduce the surface defects of the casting.  

DTH drilling refers to a method where the drilling bit is located at the end of a drill string, below the surface of the ground. This technique is distinguished by the use of high-performance percussion hammers, which are positioned on the drill bit. DTH drilling involves the use of compressed air to deliver rapid impacts, breaking rock into smaller fragments. This method is particularly effective in hard rock formations, making it a preferred choice for mining operations and various drilling applications.

Benefits of Using the CFM 185 Air Compressor