peças de triturador
- Efficiency The right materials can significantly enhance the drilling speed and reduce downtime, leading to cost savings and increased productivity.
\text{Flow Rate} = \text{Pump Displacement} \times \text{Pump Speed}
Maintaining Your Sump Pump
When the crawler pile driver is drilling, the current of the pile driver's ammeter shall not exceed 100A. If the ammeter current exceeds 100A, the drill pipe should stop and descend slowly, and the rotor always keeps turning. If the current drops below 100 amps and is stable, the drill pipe can continue to decline slowly.
The use of wood mold or lost foam requires the mold to be consistent with the real thing, the appearance is smooth, and the yield and surface finish of the casting are improved, so as to reduce flash, burr and cold separation.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.
(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.