Компоненты дробилки
4. The average flow rate of the pipeline is too low, and the average flow rate of the pipeline is lower than the critical settlement deceleration, resulting in pipeline blockage and unable to transport slurry normally. Through the above examples, it can be seen that the selection of ZJ series slurry pump is more complicated, and if any link makes a mistake, it may lead to the mistake of the entire selection, causing irreparable losses to users, and having an adverse impact on their reputation. Therefore, in the selection, we must pay attention to the values of several key coefficients and calculate them carefully to achieve accuracy, so that the ZJ series slurry pump can fully reflect its advantages in field application.
A DTH hammer is a type of percussion drilling tool that functions by delivering a series of rapid impacts to the drill bit, which then breaks the rock or other materials beneath the surface. The term down-the-hole refers to the hammer being placed directly above the drill bit, allowing the energy from the hammer to be transferred efficiently into the drill bit. This method enhances the speed and effectiveness of drilling operations, particularly in hard rock formations.
A jaw plate is a vital part of a jaw crusher. Typically, these plates are made of high-strength steel or manganese steel and are designed to withstand the immense pressure and force that occurs during crushing operations. Functionally, jaw plates serve as the primary point for the raw materials to be crushed. They work in tandem with the stationary jaw and the movable jaw, creating a V-shaped cavity that compresses materials to break them down into manageable sizes.
การเลือกซื้อคอมเพรสเซอร์ลม CFM 185
The reason:
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high
Inlet valve is not open or has silted
Suction line resistance is too high or blocked
Suction height is too high