Types of oil seals include:

Figure 6: Oil seals for cars

Modern engine oils, such as the current SG classification for gasoline engines, contain a large fraction of additives, many of which are detrimental to fluoroelastomers. The primary functions of oil-additive packages are to protect metal parts, avoid deposits in the engine, minimize oil degradation, and adjust fluid viscosity. Little attention has been paid to avoiding damage to rubber seals. Instead, elastomer producers have been expected to provide new, higher-performing products at no increased cost to auto manufacturers. Among the additives with moieties that may attack fluoroelastomers at high temperature are detergents (phenolates), dispersants (succinimides, alkylphenol amines), and antioxidants (amines, sulfides, hindered phenols).⁴ Many of these components are multifunctional, containing phenol or amine groups that can dehydrofluorinate and crosslink VDF-containing fluoroelastomers, leading to loss of elongation and eventual embrittlement. However, the rate and extent of reactions with seals are affected by many factors, including whether air is present in the system. When oil is exposed to air at high temperature, additives may undergo considerable changes. For example, a significant fraction of amines may be oxidized to amides, which have little effect on fluoroelastomers.⁵

advantage:

What material are oil seals made from?

There are many different materials used to manufacture oil seals.

(2) When the ambient temperature is high, polyacrylate or silicon, fluorine, and silicon fluorine rubber should be selected. And should try to lower the oil temperature in the tank. When the operating temperature is too low, cold-resistant rubber should be used.

In addition to carbon buildup and oil leakage, black spark plugs can also be caused by overheating. If the engine is running too hot, it can cause the electrodes on the spark plugs to wear down and become coated in carbon deposits. This can lead to poor engine performance and reduced fuel efficiency. It is important to monitor the engine temperature and address any overheating issues promptly to prevent damage to the spark plugs.

Storage and Handling

You have to consider the speed at which the shaft will be moving, the housing bore, and the runout. These are important to make sure that you choose an oil seal that will not be exposed to unconducive abrasions.