Post-processing of large castings, large foundry processing manufacturers can use liquid sandblasting to clean the oxide scale and residue on the surface of the casting, which can not only remove impurities, but also play a role in polishing and improving the surface finish of the casting; Use grinding wheels, abrasive cloths, sandpaper and other abrasives to remove impurities such as burrs, protrusions and oxide scales on the surface of steel castings, so that the surface is smooth. In addition, methods such as mechanical, electrochemical and chemical polishing can further improve the gloss and corrosion resistance of castings.

1. Centrifugal Pumps These are the most widely used pumps for slurry applications due to their simple design and efficiency. They operate by using a rotating impeller to increase the velocity of the slurry, which then converts kinetic energy into pressure energy. Centrifugal pumps are suitable for low to medium viscosity slurries and are particularly efficient for transporting large volumes at lower pressures.

Applications Across Different Fields

(1) If the horizontal slurry pump causes a blockage of solid hard deposits in the volute, measures can be taken to remove the blockage.
(2) If the shaft is different from the stuffing box axis, it is mainly due to processing errors and incorrect installation. Then pay attention to check whether the installation is correct after installation. If the sealing water ring is badly worn, a new water ring needs to be replaced. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, resulting in rapid wear of the packing, resulting in material leakage, you should dredge the blocked water pipe and keep the sealing water clean.
(3) If the impeller or the inlet and outlet water pipe is blocked, the impeller or pipe can be cleaned, and if the impeller is seriously worn, it should be replaced. If the filler mouth leaks, press the filler. If the conveying height is too high or the tube loss resistance is too large, the conveying height should be reduced or the resistance reduced.

The main components of submarine hammer drilling equipment include the drill rig, hammer, drill pipes, and the drill bit. The drill rig is often mounted on a surface vessel or a floating platform and is designed to support the excessive weight and dynamic forces encountered during drilling operations.

Equipment and Technology

2. 농업 농업에서도 압축 공기 시스템이 많이 사용됩니다. 예를 들어, 공압식 도구나 식물 보호제 스프레이를 사용하는 데 필요한 압축 공기를 공급합니다.

디젤 공기 압축기를 효율적으로 운영하기 위해서는 정기적인 유지보수가 필수적입니다. 엔진 오일 교환, 필터 청소 및 교체, 그리고 압축기 자체의 점검 등이 포함됩니다. 이러한 점검은 기계의 수명을 늘리고, 고장을 예방하는 데 중요한 역할을 합니다.